Frequently Asked Questions
| Alarm No | Alarm Message | Handle |
| 1000 | The emergency stop switch has been activated | Confirm whether the emergency stop button has been pressed: Pressed (rotate the emergency stop button clockwise to unlock) Not pressed (other emergency stop alarms have occurred; signal line is disconnected, etc.) |
| 1002 | thermal braking | Thermal braking: ▲ Turn the NC power supply to OFF and the main circuit breaker to OFF. ▲ Confirm the thermal relays OLS1, OLS4, and OLSCL |
| 1443 | Maximum length alarm in diameter direction | After retracting the material, set M01 to select the tool as the independent variable |
| 2003 | "Thread machining not executed. Press 'Start' to continue." | After pressing the start button, the thread cutting operation will automatically commence |
| SW0100 | writable parameter | Set the "Parameter Write-in" of the adjustment screen to zero |
| 1201 | Insufficient cutting oil | Confirm cutting oil quantity: insufficient (supplement cutting oil) sufficient (confirm chip status) |
| 2013 | The temperature of the control box is high | Confirm cutting oil quantity: insufficient (supplement cutting oil) sufficient (confirm chip status) |
| 1433 | The main cutting edge is fixed and closed | Unable to lock the door, confirm whether the emergency stop button has been pressed: Pressed (rotate the emergency stop button clockwise to unlock) Not pressed (other emergency stop alarms have occurred; signal line disconnection, etc.) |
| 1202 | Materials used up | After opening the spindle collet, execute the start point instruction |
| 2030 | Unable to lock the door | Confirm the material supply device's material status: When there is no material (please press the reset button after replenishing the material), there is material (material used up; fault in the detection limit switch; wiring error, cable disconnection) |
