In the actual use of the press equipment by the customer, it is inevitable that it will be installed by itself due to the change of position. So what should you pay attention to when installing a hydraulic press?
The customer should make reasonable arrangements according to the use site, pay attention to the location of the power supply, the flatness of the ground, and the foundation of the large hydraulic press.
Check whether the joints of the installed hydraulic system are firm and whether the electrical contacts are installed in place.
According to the type of hydraulic press and processing requirements, formulate targeted and feasible safety operation procedures, and carry out necessary job training and safety education.
Before starting the equipment, check whether the operating part of the hydraulic press is in an effective state, whether the safety protection device is complete and easy to use, and whether there is any abnormality in the structure of each part.
Before the official work, the machine must be idling to test the machine, and it can work only after confirming that all parts are normal. Before starting the machine, all unnecessary items on the workbench should be cleaned to prevent the sudden start of the slider caused by vibration and injury or hitting the switch.
During operation, it is strictly forbidden to directly reach into the die mouth to take things, and hand tools must not be placed on the die.
When adjusting the position of the workpiece in the die area or picking up the workpiece stuck in the die, the machine must be stopped.
Multiple people operating the same hydraulic machine should have a unified command, the signal is clear, wait for the other party to make a clear response, and confirm to leave the dangerous area before moving.
In case of sudden power failure or operation, the power supply should be turned off, and the hydraulic press should be cleaned up.
The maintenance and adjustment of the hydraulic press and the installation, adjustment and disassembly of the mold should be carried out when the hydraulic press is stopped, and pads should be placed under the slider for reliable support.
The above are the precautions for hydraulic press installation. If you need it, you can contact us ZHENGXI Hydraulics or email xdyf0428@cdzhengxi.com.
Ms.Serafina +86 15102806197
Post time: Jan-12-2022