CNC system

It converts electrical signals from the CNC controller into linear mechanical motion. To achieve this motion, signal transmission occurs between the machine tool’s CNC controller and the motor drive controller. The synchronous cylinder follows a pre‑set working profile, precisely controlling both feed motion and rapid traverse. A variable‑speed servo unit is used to regulate the position of the bending tool and the bending force throughout the bending process.

System Features

• Dual-servo technology replaces conventional valve‑control technology, eliminating throttling losses and delivering significant energy savings.
• Servo motors can withstand significant short-term overloads, and the actual installed power is only 50% of the theoretical rating, resulting in greater energy efficiency.
• The fuel tank capacity is reduced by 70%, thereby decreasing the amount of hydraulic oil used.
• Low thermal equilibrium temperature, no cooling system required, and hydraulic fluid life is extended.
• In idle, lowering, pressure-holding, and return‑stroke modes, noise levels are significantly reduced, improving the working environment.
• Dual-servo motors are 50% faster than single-servo motors, enabling quicker pressure and flow switching in emergency situations.
• Oil particle sensitivity has decreased, from NS7 to NS9.